Solder Fume Extractor

This system consists of:

• Fan
• Electrostatic filter
• Wire mesh Pre-filter
• HV powerpack control panel and the enclosure box

This equipment will be connected to the cabinet by two pipes of Dia 4” each in case of manual soldering.

The smoke is extracted through open pipe end fixed just near to soldering point. This avoids spreading of the solder fume extractor, solder fume extractor systems, soldering fume extraction, solder fume extraction system, fumes & smoke in the shop environment.

The extracted fumes & smoke pass through Pre-filter & Electrostatic filter cell and get filtered with high efficiency to exhaust clean & smoke-free air.

These filters are metallic plates charged with high voltage to attract smallest of the particles in the fumes and smoke.

These filters do not require any replacement and those can be washed and reused.

The exhaust air is clean and free from any fumes sucha as solder fume extractor, solder fume extractor systems, soldering fume extraction, solder fume extraction system, smoke filter, thus need not be thrown outside the shop with additional ducting.

One such unit can cater to two operators. Commonly the system is placed below the soldering table.